iCoat Metal Illusion Epoxy

iCoat’s Metal Illusion Epoxy is a thin-mil epoxy that has exceptional leveling properties and with the addition of iCoat SuperStains can be done in a myriad of colors. Proudly 100% USA Made

iCoat Metal Illusion Flooring Epoxy is a 100% solid crystal clear flooring epoxy. It can be combined with iCoat Metal Illusion Powders to create metallic epoxy floors or as a crystal clear sealer over iCoat’s Concrete Flooring System and regular concrete. Can also be tinted with iCoat SuperStains and/or used as a tinted sealer. For indoor use only.

Surface Preparation: The most suitable surface preparation is fine brush blast (shot blast) or light grinding to provide a suitable profile. All dirt, foreign contaminants, oil, and curing compounds must be removed to assure a trouble-free bond to the substrate. Make sure the floor surface is dry. To determine if the concrete is dry place a 4’X4′ plastic sheet on the substrate and tape down the edges. If after 24 hours the substrate is still dry below the plastic sheet, then the substrate is dry enough to start coating. For best results, apply material between 55° and 90° F with relative humidity below 85%. Lower temperatures will require more time for the material to cure. Apply with relative humidity below 85% for best results. Priming: The surface should be primed using iCoat Metal Illusion Primer to prevent outgassing and possible surface defects.

Application Instructions: MIXING RATIO: 2 parts of Part A to 1 part of Part B. Apply material without thinning. After the two parts are combined, mix well with slow speed mixing equipment such as a jiffy mixer until the material is thoroughly mixed and streak-free. After mixing, transfer the mixed material to another pail (the transfer pail) and remix. The material in the transfer pail is now ready to be applied on the primed substrate. Improper mixing may result in product failure.

Coverage:

3 gallons
200 sq ft trowelled for metallic
500-700 sq ft Rolled as clear coat

15 gallons
1000 sq ft trowelled for metallic
2500- 3500 sq ft Rolled as Clear coat

Artic white powder one 8 oz jar per 3 gallon kit for lighter colors
One 8 oz jar per two 3 gallon kits for darker colors
Super stain ½ to 4 oz per 3 gallon kit depending on desired color

Top coats for MI
Renew floor finish 500-700 sq ft per gallon
Urethane 500 450-600 sq ft per 1.5 gallon kit
TC2100 Matte 800-1000 sq ft per kit